Meyra 2.322, Maintenance And Service Manual

Page: 30 / 52

30
Rear indicator
☞
Note:
If a turn-signal bulb is defective, the remaining one
blinks at double frequency.
Filament bulb:
12V/P21W BA15s
Removal
1. Undo the securing screw (1) and remove the lens [2].
2. – Press the defective spherical bulb (3) lightly into the
holder against the spring and then turn the bulb and
pull it out of the bulb holder.
Fitting
1. Insert a new spherical bulb. – For this push the sideward
pin (bayonet-catch) into the recess of the bulb holder,
press and turn lightly against the spring until the bayo-
net-catch snaps into place [2].
2. Mount the lens, [4].
Rear light
Festoon bulb:
6V/C5W S8.5
Removal
1. Undo the securing screw (1) and remove the lens [2].
2. Press the defective festoon bulb (5) against the holding
pin and then pull it out of the holder.
Fitting
1. Insert the new festoon bulb [2]. – For this press one tip
of the soffitte into the hole in the holding pin and then
press the other tip into the hole of the other holding
pin [2].
2. Mount the lens, [4].
2
5
3
1
4