Meyer Utility Plow, Owner'S Manual And User'S Manual

Page: 10 / 36

STEP 2a
Carefully route the Vehicle Harness to the vehicle battery. Be sure to stay
away from hot, sharp or moving parts of the vehicle and use the zip ties
provided to secure. Attach the Black wire to the negative (-) battery post
(fi g. 12) and the red wire to the positive (+) battery post (fi g. 13).
STEP 2b
Carefully attach the Vehicle Harness Extension to the vehicle harness.
Be sure to stay away from hot, sharp or moving parts of the vehicle and
use the zip ties provided to secure. Connect the Controller to the Harness
Extension (fi g. 14).
STEP 2c
Install your Receiver Hitch Mount (sold separately, see hitch
requirements on pg. 4) per manufacturers instructions. Measure
center of square hitch to the ground. This dimension (A) should be a
minimum of 10” and a maximum of 13” (fi g. 15). Measure from the
hitch pin hole to the very end of your bumper. This dimension (B)
should be not more than 8-1/2” (fi g. 15). If your dimension does
not fall within these ranges you should contact your hitch dealer/
manufacturer for height or length adjustment accessories.
STEP 2:
WIRING INSTALLATION
(A) 10” min-13” max
(B)
8-1/2” max
(Fig. 15)
8
(Fig. 12)
(Fig. 13)
(Fig. 14)
24, 25, 26, 27, 28
9, 20, 21
SAFETY PRECAUTIONS - See pages 2-3 for defi nitions