Meyer STELLA-188, Operating Instructions Manual

Page: 18 / 28

CHAPTER 3: STELLA MOUNTING OPTIONS
18
Mounting the Stella-4 with the MMB Bracket
To mount the Stella-4 with the MMB bracket:
1. Separate the MMB wall plate from the MMB loudspeaker
plate by unscrewing the thumbscrew.
2. Mount the MMB wall plate to the wall with one of the fol-
lowing options. Position the wall plate so its hinges are
pointing up.
■ Mount directly to the wall surface using screws in the
four corner holes. Use fastening hardware appropriate
for the mounting surface.
■ Mount on a single-gang electrical back box using screws
in the two center holes (top and bottom).
3. Attach the MMB loudspeaker plate to the back of the
Stella-4 using screws in the four corner holes. The loud-
speaker plate should be positioned parallel to the heat
sink grooves on the back of the Stella-4 (so the Stella-4's
Phoenix connector is
not covered).
4. Attach the loudspeaker plate to the wall mount using the
hinges and tighten the thumbscrew with a screwdriver
(but don't over-tighten it).
Mounting the Stella-4 with the MMB Bracket
and OmniMount 20.5 ST
To mount the Stella-4 with an MMB bracket and OmniMount
20.5 ST:
1. Separate the MMB wall plate from the MMB loudspeaker
plate by unscrewing the thumbscrew.
2. Attach the MMB loudspeaker plate to the back of the
Stella-4 using screws in the four corner holes. The loud-
speaker plate should be positioned parallel to the heat
sink grooves on the back of the Stella-4 (so the Stella-4's
Phoenix connector is
not covered).
3. Attach the OmniMount mounting plate to the MMB loud-
speaker plate using screws in the two center holes (top
and bottom).
4. Attach the mounting plate to the OmniMount ball-clamp
assembly according to the manufacturer's instructions.
Mounting the Stella-4 with the MAMB Adjust-
able Bracket
To mount the Stella-4 with an MAMB adjustable bracket:
1. Separate the MAMB wall plate from the pivot plate
assembly by removing the center screw and washers.
2. Mount the MAMB wall plate to the wall with one of the
following options.
■ Mount directly to the wall surface using screws in the
four corner holes. Use fastening hardware appropriate
for the mounting surface.
■ Mount on a single-gang electrical back box using screws
in the two center holes (top and bottom).
3. Attach the MAMB pivot plate assembly to the Stella-4
using screws in the four corner holes. The pivot plate
assembly should be positioned parallel to the heat sink
grooves on the back of the Stella-4 (so the Stella-4's
Phoenix connector is
not covered).