Meyer STELLA-188, Operating Instructions Manual

Page: 19 / 28

STELLA OPERATING INSTRUCTIONS
19
4. Attach the pivot plate assembly to the wall plate using
the screw and washers previously removed. Tighten the
screw.
5. To adjust the position of the Stella-4, loosen the four
pivot plate screws and position the Stella-4 as neces-
sary. Tighten the pivot plate screws to secure the
Stella-4.
MOUNTING THE STELLA-4C
The Stella-4C can be mounted flush in ceilings and walls
with any standard 8-inch backbox (such as the Atlas
BMT95-8-7, Lowell CP-87 or XCP-87) with a minimum
depth of 6.5 inches.
Installing the Stella-4C in a Backbox
To install the Stella-4C in a standard 8-inch backbox:
1. Mount the backbox in the ceiling or wall according to the
manufacturer's instructions.
2. Place the Stella-4C in the backbox and secure it with the
8-32 screws included with the Stella-4C.
3. Attach the Stella-4C grille frame:
■ Screw the three threaded studs (included with the
Stella-4C) into the Stella-4C grille frame.
■ Attach the grille frame to the Stella-4C by inserting the
other ends of threaded studs into the three nylon latches
in the Stella-4C.
■ Gently push the grille frame in until it locks in place flush
with the wall or ceiling.
NOTE: The Stella-4C’s grille frame is held in
place with three nylon latches. To remove the
grille frame, gently pull it, evenly, until it releases from
the latches.
Backbox
Stella-4C
grille frame
Stella-4C