1.
Before filling Hopper, make sure spreader
Handle Lever is in the “OFF” position. Always fill
spreader on walk or drive, not on the lawn.
2.
Loosen Rate Control Knobs and move the Tie
Bar to the desired setting. If setting is not known,
try different settings until desired results are
achieved. Retighten knobs after setting is made.
3.
Always push spreader, do not pull.
Start spreader in motion and as it passes
over the area to be treated, push Handle
Lever to the “ON” position. Close Handle
Handle Lever at the end of each pass.
4.
Operate spreader at 2 1/2 MPH pace.
(18 feet in 5 seconds)
5.
Apply two header strips at each end
of area to treated and then proceed
lengthwise between the header strips.
Be sure to overlap the wheel tracks
slightly to prevent missed strips.
6.
Apply ice melt prior to the storm to
reduce unmanageable levels of ice and
snow.
1.
Never store unused material in spreader. Return
unused product to its original container.
2.
Set Rate Slide on the highest number, open
spreader and spin Wheels to remove excess material.
3.
Wash out Hopper thoroughly after each use to
remove material clinging to surfaces. Pay close
attention to area between the Shutoff Bar and Hopper.
Allow spreader to completely dry.
4.
Oil bottom of Hopper, Control Housing Spring and
Agitators at the Center Bearing. Lubricate Axle
Bearings with grease. Store spreader in open position.
Oil
Oil
Grease
Grease
Oil
“Open”
WARRANTY
OPERATION
Meyer Products warrants to Purchaser the following:
Meyer Products, Inc., warrants to the original purchaser for a period of one
year from the date of purchase of Meyer® and Diamond® brand spreader
products that they will be free from defects in materials or workmanship,
with the exceptions stated below. No person is authorized to change this
warranty or to create any additional warranty on Meyer®/Diamond®
products.
Meyer Products will repair any product that proves to be defective in materi-
als or workmanship. In the event repair is not possible or practical (as deter-
mined by Meyer Products in its sole discretion), Meyer Products will either
replace the product with a new product of similar model and price, or refund
the full purchase price, as determined by Meyer Products. Customer must
keep the complete spreader system serviced/maintained as recommended
by Meyer Products.
This warranty does not cover:
• Problems caused by failure to follow the product instructions, or failure to
maintain the product as described in the Operator’s Manual;
• Damage resulting from rust, corrosion
• Damage caused by usage that is not in accordance with product instruc-
tions (use of the spreader for any purpose other than spreading approved
material is considered misuse and abuse);
• Any spreader, or any part, component, or assembly thereof, which has
been modified or altered;
• Problems caused by using accessories, parts, or components not supplied
by Meyer Products;
• Cost of tax, freight, transportation or storage charges, environmental
charges, solvents, sealants, lubricants or any other normal shop supplies.
• Problems caused by collision, fire, theft, vandalism, riot, explosion, light-
ning, earthquake, windstorm, hail, water, flood, or any other Acts of God;
• Liability for damage to property, or injury to, or death of any person arising
out of the operation, maintenance or use of the covered product;
• Products with missing or altered serial numbers;
How To Get Service:
• It is the responsibility of the original purchaser to establish the warranty
period by verifying the original delivery date. A bill of sale, cancelled check
or some other appropriate payment record may be kept for that purpose. It
is recommended, but not required, that the consumer verify the original
delivery date by immediately returning the attached Warranty Registration
Card.
How State Law Applies:
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
MAINTENANCE
