OPERATION
1.
Before filling hopper, make sure spreader is in the
“OFF” position. Always fill spreader on walk or drive,
not on the lawn.
2.
Turn the rate control dial to the desired setting. If
setting is not known, try different settings until desired
results are achieved.
3.
Always push spreader, do not pull. Start spreader
in motion and as it passes over the area to be treated,
move the thumb release to the “ON” position. Close
spreader at the end of each pass.
4.
Operate spreader at 2 1/2 MPH pace (18 feet in 5
seconds).
MAINTENANCE
1.
Never store unused material in spreader. Return unused product to its original container.
2.
Set rate dial on the highest number, open spreader and spin wheels to remove excess
material.
3.
Wash out hopper thoroughly after each use to remove material clinging to surfaces. Pay
close attention to area between the shutoff bar and hopper. Allow spreader to completely dry.
4.
Oil the axle bearings and the control knob wire. Store spreader in open position.
5.
Apply two header strips at each endof area to be treated
and then proceed lengthwise between the header strips. Be
sure to overlap the wheel tracks slightly to prevent missed
strips.
6.
Apply ice melt prior to the storm to reduce unmanageable
levels of ice and snow.
WARRANTY
Meyer Products warrants to Purchaser the following:
Meyer Products, Inc., warrants to the original purchaser for a period of one year from the date of purchase of Meyer® brand spreader products that they will be free from
defects in materials or workmanship, with the excepons stated below. No person is authorized to change this warranty or to create any addional warranty on Meyer®/
products.
Meyer Products will repair any product that proves to be defecve in materials or workmanship. In the event repair is not possible or praccal (as determined by Meyer
Products in its sole discreon), Meyer Products will either replace the product with a new product of similar model and price, or refund the full purchase price, as deter-
mined by Meyer Products. Customer must keep the complete spreader system serviced/maintained as recommended by Meyer Products.
This warranty does not cover:
• Problems caused by failure to follow the product instrucons, or failure to maintain the product as described in the Operator’s Manual;
• Damage resulng from rust, corrosion
• Damage caused by usage that is not in accordance with product instrucons (use of the spreader for any purpose other than spreading approved material is considered
misuse and abuse);
• Any spreader, or any part, component, or assembly thereof, which has been modified or altered;
• Problems caused by using accessories, parts, or components not supplied by Meyer Products;
• Cost of tax, freight, transportaon or storage charges, environmental charges, solvents, sealants, lubricants or any other normal shop supplies.
• Problems caused by collision, fire, the0, vandalism, riot, explosion, lightning, earthquake, windstorm, hail, water, flood, or any other Acts of God;
• Liability for damage to property, or injury to, or death of any person arising out of the operaon, maintenance or use of the covered product;
• Products with missing or altered serial numbers;
How To Get Service:
• It is the responsibility of the original purchaser to establish the warranty period by verifying the original delivery date. A bill of sale, cancelled check or some other
appropriate payment record may be kept for that purpose. It is recommended, but not required, that the consumer verify the original
delivery date by immediately returning the a8ached Warranty Registraon Card.
How State Law Applies:
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
