Meyer F585 2018, Owner'S/Operator'S Manual

Page: 22 / 92

Meyer Manufacturing Corporation - 22 - PB-MIXER-TR-MECH
10. Check that all hardware is in place and is tight.
11. Watch for any worn or cracked welds. If found, have qualified personnel repair immediately or replacement is
necessary.
12. Check all bearings for wear. Replace as needed.
13. Inspect any wear items. i.e.: Knives, scrapers, kicker wear plate. Replace as required.
6.2 TRUCK MOUNT SPECIFICATIONS
See the truck mount specifications on the www.meyermfg.com website.
6.3 PTO DRIVELINE
6.4 START-UP AND SHUT-DOWN
6.4.1 Start-Up
Enter the truck and start the engine.
Be sure no one is inside the mixer and mixer is empty.
Check to see that the discharge door is closed.
Verify the two speed gearbox is engaged in low gear.
Slowly engage the PTO at idle speed.
Bring engine RPM up to 3/4 to full RPM.
Shutoff and lockout power before performing machine service,
adjusting, maintaining, or clearing an obstruction from this machine.
Refer to section 5.3 SHUTOFF & LOCKOUT POWER.
Do not operate without PTO guard on implement. Maintain PTO drive
shaft guard tubes in good operating condition. Replace them if
damaged and not turning freely. Failure to heed may result in serious
personal injury or death.
DO NOT allow anyone to operate, service, inspect or otherwise handle
this equipment until all operators have read and understand all of the
instructional materials in this Operator’s And Parts Manual and have
been properly trained in its intended usage.
Before operating the equipment, look in all directions and make sure
no bystanders, especially small children are in the work area.
Shutoff and lockout power before performing machine service,
adjusting, maintaining, or clearing an obstruction from this machine.
Refer to section 5.3 SHUTOFF & LOCKOUT POWER.
Always keep all shields and guards in place and securely fastened.
Keep hands, feet and clothing away.