Meyer 8720 Operators, Operator And Parts Manual

Page: 8 / 92

Model 8720 / 8865 -8-
3. SAFETY PRECAUTIONS
CAUTION: BEFORE ATTEMPTING TO OPERATE THIS SPREADER, READ AND STUDY THE
FOLLOWING SAFETY INFORMATION. IN ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO
OPERATES OR WORKS WITH THE SPREADER, WHETHER FAMILY MEMBER OR EMPLOYEE, IS FAMILIAR
WITH THESE SAFETY PRECAUTIONS.
Require anyone who will operate this spreader to read and completely understand this Owner’s Manual. Give
necessary instructions!
DO NOT operate, service, inspect or otherwise handle this spreader until all operators have read this Owner’s
Manual and have been properly trained in the intended usage of the spreader.
Do not allow minors (children) or inexperienced persons to operate this spreader.
If the spreader becomes clogged, shut off the tractor engine and allow all mechanisms to stop. Disconnect PTO
shaft and hydraulic hoses (relieve hydraulic pressure). Then, clean or work on the spreader as required.
Always shut off power and disconnect PTO drive shaft and unhook hydraulic hoses (relieve hydraulic pressure)
from tractor to prevent accidental startup or unexpected movement before working on machine.
Do not clean, adjust, or lubricate while spreader is in motion.
Make sure all hydraulic fittings are tight and that all hoses are in good condition. Hydraulic fluid escaping under
pressure can have sufficient force to penetrate skin and cause serious injury. Never investigate for hydraulic leaks
by using a part of the body to feel for escaping fluid.
Inspect when first delivered and regularly thereafter. Verify that all connections and bolts are tight and secure
before operating.
Know how to stop the spreader before starting it!
Do not operate until all shields, covers and guards are in place.
Make certain everyone is clear of the spreader before applying power.
Keep hands, feet and clothing away from moving parts. Loose or floppy clothing should not be worn by the
operator.
Stay well clear of the spreader’s rear discharge spinners while operating.
Do not step up on any part of the spreader at any time. Do not use PTO guard as a step.
Do not step over the power take-off shaft. Stay clear of the PTO at all times.
Keep PTO shaft telescoping tube shields turning freely. Keep PTO master shield on tractor. Replace shields
missing or damaged.
Match the right tractor PTO spline and speed with the PTO driveshaft provided with the implement. This will assure
proper geometry and operating speed. Never operate 540 RPM implements at 1000 RPM. Never operate 1000
RPM implements at 540 RPM. Never use a spline adapter. Use of adaptors will void warranty due to damage
caused to the tractor PTO, PTO driveshaft or implement.
Use only properly rated tires.
Do not tow at speeds in excess of 20 MPH when transporting this spreader. Never exceed a safe travel speed.
Observe all applicable traffic laws when transporting on public roadways (where legal to do so). Check local laws
for all highway lighting and marking requirements.
Always install a SMV emblem on this spreader for transporting on roadways and keep the emblem clean and bright.
When towing the spreader on public roads a safety chain of sufficient strength to support, along the line of
travel, the gross weight of the spreader must be used (See Maximum Load Weight Chart in the Transporting
Section). The safety chain should be attached per diagram in the Transporting Section.
STUDY THE ABOVE SAFETY RULES
FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.