Meyer Sound MPS-488HP, Operating Instructions Manual, Page: 14 / 36

CHAPTER 3: POWERING LOUDSPEAKERS WITH THE MPS-488HP
14
■
When connecting loudspeakers equipped with EN3 con-
nectors to the MPS-488HP
E
power supply, use EN3 5-
pin male to EN3 5-pin female cables.
■ To join two EN3 cables, one with an EN3 5-pin male
cable mount connector to one with an EN3 5-pin female
cable mount connector, use an EN3 5-pin female-to-
male cable coupler (PN 28.163.033.01).
■ When connecting loudspeakers equipped with ECO-M
connectors to the MPS-488HP
P
power supply, use
Phoenix 5-pin female to ECO-M 7-pin female cables.
CAUTION: Make sure loudspeaker cables are
wired correctly. For details on assembling loud-
speaker cables, refer to Appendix B, “Assembling
Loudspeaker Cables.”
5. Power on the MPS-488HP and monitor the LEDs on its
front panel to verify the connections (see “Voltage and
Load Current LEDs (1–8)” on page 7).
6. Check loudspeaker LEDs to verify whether the loud-
speakers are ready to reproduce audio.
7. Enable output from the audio sources (from the mixer or
processor) connected to the MPS-488HP.
MPS-488HP
E
with Eight UP-4XP Loudspeakers
MPS-488HP
E
!