- 7 -
Step by Step Operation Guide for Treatment
Preparing the Skin for Running a Session
Proper preparation of the skin covered by the electrodes allows more stimulation to reach targeted
tissues, prolongs electrode life, and reduces the risk of skin irritation. After connecting the lead
wire(s) to the stimulator, use the following steps to prepare your skin at the electrode placement
sites:
1. Determine the placement sites for the electrodes.
2. Wash the area with mild soap and water (do not use alcohol). Rinse and dry thoroughly.
3. Trim excess body hair from the area with scissors (do not shave).
4. When removing electrodes, always remove by pulling in the direction of hair growth. Pull up a
corner of the electrode to remove it.
Do not remove the electrode by pulling on the lead wire.
5. It may be helpful to apply skin lotion on treatment area after treatment.
Inserting/Changing the Batteries
1. Open the battery compartment at the back of the device by pushing the battery cover labelled
“Open” downward (this area features raised marks for easy identification).
2. Insert 3 AAA (1.5 V) batteries in the battery compartment; make sure to match up the symbols
(+/–).
3. Close the battery cover by carefully placing the stud into the slot in the rear area and sliding it
upward, applying slight pressure.
4. Follow the same procedure when replacing the battery at a later date.
▲
Note
: for important precautions regarding the batteries ,please be informed:
Always use only 3 x 1.5V (AAA) batteries.
Keep away from children.
Do
not
recharge.
Do
not
short-circuit.
Do not throw into a fire.
Please recycle. Do not dispose of old batteries with your household waste; dispose of them
safely at your recycling center.
