04 I
M A I N T A N C E A N D C A R E
• When not in use please power OFF the tool and place the pendulum
lock in its locked position.
• In Manual Mode, self-leveling is OFF. The accuracy of the beam is not
ensured to be level.
• The laser tool is sealed and calibrated at the plant to the accuracy
specified.
• It’s recommended to carry out an accuracy check before its first use
and periodic checks during future use especially for precise layouts.
• Do not store the laser tool in direct sunlight or expose it to high
temperatures.
The housing and some internal parts are made of plastics and may
become deformed at high temperatures.
• Exterior plastic parts may be cleaned with a damp cloth. Although
these parts are solvent resistant, NEVER use solvents. Use a soft, dry
cloth to remove moisture from the tool before storage.
• Store the tool in its case when not in use. If storing for extended time,
remove batteries before storage to prevent possible damage.
• Do not dispose of this product with household waste.
• Always dispose of batteries per local code.
• Please recycle in line with local provisions for the collection and
disposal of electrical and electronic waste under the WEEE Directive.
B A T T E R Y S A F E T Y
• Keep the battery away from children, and pets.
• Please pay attention to the position of the positive and negative pole.
• Please replace new alkaline batteries instead of carbon batteries. The
battery capacity should be more than 1500mA each.
• Do not mix old and new batteries. Replace all of them at the same
time with new batteries of the same brand and type.
• When the device will not be used for a long time, please remove the
batteries and store them in dry condition.
Summary of Contents for ML3
Page 1: ...ML3 ML3G MANUAL ...
