11(19)
Certification of the device.
3.2 Device menu
The device menu contents is shown in the figure 6.
Figure 6. Device Menu
3.2.1 Operation
3.2.1.1 Page AUTO
The page AUTO in the operation window is presented in
figure 7. From this window it is possible to change the op-
erating mode of the device and change the value of the
auto-mode valve position setpoint (SP).
If the cyclic communication is running and it is using a GSD
module that has the SP included, it is not possible to write
the Setpoint from here.
If it is desired to control the valve independent of the con-
trol system, see page MAN.
Figure 7. Operation / Auto.
3.2.1.2 Page Remote Cascade
The page Remote Cascade in the operation window is pre-
sented in figure 8. From this window it is possible to
change the operating mode of the device and change the
value of the RCAS-mode valve position setpoint
(RCAS_IN).
Figure 8. Operation / RCAS.
3.2.1.3 Page MAN
The page MAN in the operation window is presented in fig-
ure 9. From this window it is possible to change the oper-
ating mode of the device and change the value of the man-
ual-mode valve position setpoint (OUT).
Figure 9.
Operation / MAN.
3.2.1.4 Page Simulation
The page Simulation in the operation window is presented
in figure 10. From this window it is possible to en-
able/disable the simulation function and simulate the
Readback value and status.
