Sump Boss
Metropolitan Industries, Inc.
www.metropolitanind.com
OPERATION MANUAL
Dated: 9/17/09
Supersedes: None
Document No.: SBossO&M
Page 17 of 19
Register your product at
www.sumpro.com
AUXILIARY POWER SYSTEM
INTRODUCTION:
Metropolitan SUMP BOSS Auxiliary Pump
System, BP 2000, is recommended as a
battery backup for residential sump pumps
and is not intended for use as an auxiliary
power system for appliances or other non-
sump pump electrical devices.
The above noted Metropolitan product
is guaranteed to be in perfect condition
when it leaves our factory. During the
time periods and subject to the conditions
hereinafter set forth, metropolitan Pump
Company, subsidiary of Metropolitan
Industries, Inc. will repair or replace to
the original user or consumer any portion
of your new Metropolitan product which
proves defective due to materials or
workmanship of Metropolitan. At all times
Metropolitan shall have and possess the
sole right and option to determine whether
to repair or replace defective equipment,
parts or components. Damage due to
lightning or conditions beyond the control
of Metropolitan is NOT COVERED BY
THIS WARRANTY. The warranty does not
cover any unit which has been damaged
either in transit or by misuse, accident or
negligence.
THIS WARRANTY WILL NOT APPLY:
1. To defects or malfunctions resulting
from failure to properly install, operate,
or maintain the unit in accordance with
printed instructions provided.
2. To failures resulting from abuse,
accident or negligence.
3. To units which are not installed in
accordance with applicable local codes,
ordinances and good trade practices.
4. If unit is used for purposes other
than for what it was designed and
manufactured.
5. If unit is exposed to, but not limited to,
the following: sand, gravel, cement,
grease, plaster, mud, tar, hydrocarbons
or hydrocarbon derivatives (oil,
gasoline, solvents, etc.) or other
abrasive or corrosive substances.
6. If power cord has been cut or the
grounding prong has been removed.
7. If unit has been dismantled by customer.
8. Batteries not meeting the above
specifications have been used.
9. Unit has been submerged in water.
10. Unit has been applied to products
exceeding the maximum capacity of
the unit, as specified in the instructions
and on the unit front label.
11. Unit has been applied to the wrong
voltage.
