DL7, DL7L
65
!
After the confirmation of changes, the data will be changed immediately
without rebooting the device.
12.1.4 Service
The maintenance tab is only available to the Administrator and enables execute
following tasks:
Restart
– results in restart of the device.
Restore Factory Settings
– using the function will result in deleting all of the earlier
settings, the archive files created so far will not be deleted (more in section
).
Serial number and MAC address
– enables displaying the serial number and MAC
address.
Configuration of HART cards
– enables configuration of installed HART cards. After
selecting a card from the list and pressing the
Configure card
button, the configuration
window of transmitters connected to the card appears.
Notes:
There is a
Resistor 250 Ω
field in the window, used for service setting on/off of
the resistor. After opening the window, the resistor status complies with the
saved (currently used) settings in the I/O window. Turning on the resistor may
be necessary to power the sensors. Before switching on the resistor, used
electrical connection should be taken into account. After closing the window, the
resistor status will be restored to the saved settings.
In the window, enter the short address of the device (0-15) and press the
Get a long
address
button. The long address is necessary during reading the values of variables
from devices in rev 5, in rev 6 and in rev 7. The test frame read for the variable PV is
displayed below. In the window it is possible to change the short address of the device:
enter the short address and communicate with the device (
Get a long address
), then in
the
Change the short address to
field enter a number from the range 0-15 and press the
Change
button.
12.2 Input and output settings
The window enables configuration of connected measurement cards. From the drop
down list (in the upper left corner) select the number of the measurement card slot.
Having selected a suitable measurement card slot from the list, it is possible to program
the individual inputs and outputs of the module. Selecting a suitable item from the list, the
type of installed card will be displayed. User can use tabs, which corresponds to the
consecutive input/output. The user can define the operating mode for each input/output
(regardless of the other inputs/outputs).
If there is no installed card (module) or the PSBATT module in version 1.0 or in version
1.1 is installed, the "-------" symbol will be displayed.
