11
Figure 10.
I
NSTALLING THE
S
CANNER TO THE
H
OST
S
YSTEM
Integrated USB: Full Speed (-40)
Low Speed (-38)
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector of the USB cable into the
jack on the scanner. You will hear a
‘click’ when the connection is made.
3. Connect the other end of the USB
cable to the host USB port.
4. Turn on the host system.
As a default, the MS95
x
0
-38
leaves the factory with USB Keyboard
Emulation Mode enabled.
For information on configuring the MS95
x
0
-38
for USB Serial
Emulation Mode, please refer to the USB section of the MetroSelect
Single-Line Configuration Guide (
MLPN
00-02544).
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration
Guide or MetroSet
2
’s help files for instructions on changing the
scanner’s factory default configuration. The scanner and host system
must use the same communication protocols.
See caution on page 6.
Summary of Contents for MK9520-37A38
Page 53: ...49...
Page 54: ......
Page 55: ...April 2008 Printed in China 0 0 0 2 4 1 0 K...
Page 56: ...January 2008 Version 03 Printed in the USA 0 0 0 2 4 1 0 J...