Insert a new module for the Multi Autolab Cabinet
Figure 19 – Analog bus connector for the BA module
Figure 20 – Analog bus connector for the FRA32M module
The dedicated analog bus connectors for the pX1000 and the BA modules can only be
installed in one way. Both the white universal M101 or M204 connector and the module
specific green connector only fit the corresponding holders on the modules in one direction.
Additional information is therefore not required.
The connector for the FRA32M, shown in Figure 20 comes with three different SMB
connectors. A white label is wrapped around each cable. The long cable is labelled ‘DSG’,
while the two shorter ones are labelled ‘E’ and ‘I’, respectively. These cables must be
connected to the optional FRA32M module, according to the instructions shown in Figure
21.
15 |
P a g e
