￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation and maintenance
Optrode
￭￭￭￭￭￭￭￭
11
6.1903.030
Figure 10
Switching the LED
2
Briefly move the magnet up and down again.
Moving the magnet switches to the next LED.
3
Move the magnet again until the desired wavelength is set.
Switching between LEDs via tiamo
The Optrode is recognized automatically by the control software
tiamo
(version 2.5 and higher). However, this only works if the Optrode is con-
nected directly to the titrator or control instrument via USB.
The wavelength is changed as follows in
tiamo
:
1
Double-click on the command in the method run.
2
Open the
General/Hardware
tab.
3
Under
Sensor
, select the option
Optrode
.
4
Under
Wavelength
, select the desired wavelength.
(A wavelength of 610 nm is suggested by default, no matter what
wavelength the Optrode is currently set to.)
The selected wavelength can later be used in the formula editor as
variable (
.WVL
).
Summary of Contents for 6.1115.000
Page 1: ...Optrode Manual 8 109 8054EN 2015 10 06 ...
Page 2: ......
