WC-SERIAL USER MANUAL
76-02-103 Rev.C
Page 14 of 17
2.2.6 Network Port Configuration
Bit switches 6 to 8 are used to configure the setting for the LAN ports of the device
and are used on installation to ensure the WC-Serial physical interface matches that
of the host port it will connect to.
2.2.6.1
Switch 5, Duplex
This switch controls the duplex mode of the user LAN ports. When auto negotiation
is enabled this controls the advertised options, whilst in manual mode, it controls the
duplex mode.
ON
Full Duplex
OFF
Half Duplex
2.2.6.2 Switch 6, Speed
This bit switch is used to select the speed control for the LAN port. When auto
negotiation is enabled, these switches control the options that are advertised,
whereas in manual mode, the speed switches actually select the interface speed.
BitSw 6
Speed
Auto Neg Advertise
OFF
100M
10/100
OFF
10M
10
2.2.6.3 Switch 8, Auto Negotiation
The Auto Negotiation switch controls whether the user LAN ports are configured
automatically, or manually.
ON
Auto Negotiation Enabled
OFF
Manual controlled selection of speed and duplex
