Congratulations and thank you for your purchase of the Metrix Audio UTV 1 kit! Since
positive word of mouth is the best way to grow our business, we want your new
system to work as well as it was designed to. If you have any questions or concerns,
we are here to help. Please email [email protected], or call us during regular
business hours (EST) at (705)-719-6361. If you still need help, then please consider a
professional installation by your retail dealer.
Important Notes Before Starting:
The BT-1 Bluetooth® receiver/controller has no audio transmitter functions. It is a
receiver only and will not allow you to make phone calls or send music to headsets.
The supplied “Element X” is a 2 channel amplifier rated at 75 watts per channel at 4
ohms. It comes equipped with 2 pairs of stereo output plugs (1 pair of left and right
“Mains”, and 1 pair of left and right “EXT’s”) allowing a total of 4 (2 pairs) 4 ohm
speakers to be powered by the single amplifier. As this kit comes, the amp will power
one set of speakers, but adding a second set of Element 1 speakers (4405-0505) can be
done easily at anytime without requiring the purchase of an additional amplifier.
The supplied Element 1 speakers were designed so they could be installed on the roll
cage down tubes in FRONT of the driver and passenger. From an audio perspective,
this is the preferred placement. The speakers can also be mounted behind the driver/
passenger. The speakers were constructed specifically for the Powersports world and
can withstand the elements. Normal rain or going through puddles etc is perfectly OK.
Normal washing is also OK, but damage to the speaker, or speaker failure caused from
pressure washing will NOT be covered by warranty.
Getting Started:
Locate the BT-1 Bluetooth® receiver/controller. It is a “snap in” piece that will fit the
common switch (21mm x37mm) “blank” found on most UTV dash boards. If your
machine does not have an empty “blank” or you want to do something custom, please
see the cutting dims on page 9. Once you choose an opening where you would like to
install BT-1, please have a good look to make sure there will be room behind the
opening for wires and the balance of the unit to snap in easily.
BT-1 Wire Color Codes
Taking your time and making secure wire connections is never a bad idea!
Black: The black wire must be connected to a good chassis ground (B-)
Red and Yellow : In this install, these 2 wires are to be joined together. See the 2
options below and select the one that works best for you. Once you decide, it’s a good
idea to refer to your vehicles manual for a suitable B+ power source.
A) If you want the unit to turn on/off only when your vehicles key is in the on
position, the yellow wire should be connected to a sw12v power source.
B) If you want to be able to turn this unit on/off regardless if your vehicles key is on
or off, the yellow wire should be connected to a co12v power source.
2
11
Warranty Information:
Metrix Audio’s UTV 1 kit is warranted for a period of 24 months from the
original purchase date. The warranty applies to the original (retail) owner of
the system only. Proof of purchase is required for all warranty claims. Please
visit the warranty section of our website and fill out the form, or email or
phone us. Products found to be defective during the warranty period will be
repaired or replaced (with a product deemed to be equivalent) at Metrix
Audio’s sole discretion.
USA Tel: (608) 554-7631
Canada Tel: (705)-719-6361.
Email: [email protected]
Website: www.metrixaudio.com
What Is Not Covered:
1) Any expense related to the removal or re-installation of this system.
2) Warranty to products with missing or defaced serial numbers.
3) Damage due to improper wiring.
4) Repairs of any kind performed by anyone other than Metrix Audio.
5) Subsequent damage to any other components.
6) Any product purchased from a non-authorized Metrix Audio dealer.
7) Damage from an accident or collision.
8) Damage from any custom mounting.
9) Damage to amp from obvious submersion in water or any other liquid.
10) Damage to speakers from “pressure washing”.
11) Speakers arriving to us with holes of any kind (or size) in cones.
12) Goods arriving to us damaged from improper shipping.
Metrix Audio is owned by PowerSports Audio Inc
