Monitor and Cue Controllers
299
The Cue Controller Interface
There are two important Cue Controller commands which appear in the menu bar Monitor pulldown menu:
Figure 11.3: Monitor menu Cue commands
•
Hide Cue Controller
is a toggle to show/hide the Cue Controller interface, with the default key com-
mand “C”.
•
Add Cue Controller
adds a Cue. Hit the default key command “P”. As you add more Cues, they will
stack progressively below the Talkback control header.
As always, the default key commands are editable under the menu bar
The Cue Controls interface itself consists of two sections.
The top section is for setup and control of the Talkback source and Listenback which will feed all Cue
sends, plus Dim level settings (shown here at their default values).
Talkback & Listenback controls
Cue #1
Cue #2
Cue #3
Figure 11.4: Cue Controls interface with three Cues
The section below is the Cue sends stack (shown above with 3 cue sends set up). As you add more cues,
new cues will add to the bottom of the cues interface.