METRA. The World’s best kits.™
metraonline.com
1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
Installation Instructions for HYBL-04
REV
. 11/4/2013 INSTHYBL-04
(continued on next page)
Interface components
• HYBL-04 Interface • 16-pin harness with stripped leads
•18-pin to 24- and 18-pin connector
tools requIred
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
HYBL-04
Hyundai/Kia SPIDIF amplifier/Blue Link
interface 2010-up
HYundaI
Azera
2012-2013
Elantra
2011-2013
Genesis Coupe
2013-up
Sonata
2011-up
Tuscon (non NAV)
2010-up
KIa
Optima
2011-up
Soul
2012-up
Sportage
2011-up
applIcatIons
features
• Retains factory Blue link
• Provides navigation outputs
• USB updatable
• Retains fade and balance
• Used with the SPIDIF amplified systems
• Retains factory 3.5 mm jack
• High level speaker input
• Prewired ASWC-1 harness included
connectIons on tHe Interface
from the 16-pin harness with stripped leads:
• Connect the
red
wires to the ignition wire of the aftermarket radio.
• Connect the
White
wire to the left front positive speaker output of the
aftermarket radio.
• Connect the
White/Black
wire to the left front negative speaker output of the
aftermarket radio.
• Connect the
Gray
wire to the right front positive speaker output of the
aftermarket radio.
• Connect the
Gray/Black
wire to the right front negative speaker output of the
aftermarket radio.
• Connect the
Green
wire to the radio’s left rear positive speaker output.
• Connect the
Green/Black
wire to the radio’s left rear negative speaker output.
• Connect the
purple
wire to the radio’s right rear positive speaker output.
• Connect the
purple/Black
wire to the radio’s right rear negative speaker output.
• Connect the
Blue/White
wire to the radio’s amp turn on wire (this wire must be
connected to hear sound from the factory amplifier).
• For Hyundai models only, connect the
Brown
wire to the mute wire of the
aftermarket radio. If the aftermarket radio does not have a Mute wire, tape up the
Brown
wire (note, if the mute wire is not connected, the radio will turn off when
Blue Link is active). For Kia models, tape up this wire.
• The
light Green
wire will not be used in this application.
• Connect the
Green/purple
wire to the reverse wire of the aftermarket
navigation radio.
• The
Blue/pink
wire will not be used in this application.
• The
orange/White
wire will not be used in this application.
Caution: Metra recommends disconnecting the negative battery terminal before beginning
any installation. All accessories, switches, and especially air bag indicator lights must be
plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
