3
REV. 1/30/2020 INSTAXDSPX-HD1
1.
Remove the fairing to access the back of the factory radio. Refer to
,
part number 99-9600 for fairing disassembly instructions.
2.
Install the
AXDSPX-HD1 harness
and make all necessary connections, but leave the amp
turn-on wire disconnected.
3.
With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the
AXDSPX-HD1
harness
into the left side of the cap. The locking clip on the connector
should face upward. Make sure the gasket is seating properly in the cap. (Figure A)
4.
With the arrow stamped onto the cap still facing upwards, push the 20-pin connector from
the
AXDSPX-HD1 harness
into the right side of the cap. The locking clip on the connector
should face upward. Make sure the gasket is seating properly in the cap. (Figure A)
5.
Plug the 16-pin and 20-pin connectors from the
AXDSPX-HD1
harness
into the
AXDSP-X circuit board
. (Figure A)
6.
Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location in the fairing to secure it. Make sure the Axxess logo is facing up to further
ensure that no outside elements can enter the enclosure.
INSTALLATION
Cap (with O-ring)
Case
AXDSP-X
Circuit Board
AXDSPX-HD1
Harness
16-Pin
20-Pin
Gasket
Zip-tie Mounts
(Figure A)
Continued on the next page
Summary of Contents for AXXESS AXDSPX-HD1
Page 5: ...5 REV 1 30 2020 INSTAXDSPX HD1...
Page 6: ...6...
