manualshive.com logo in svg

Metra Electronics 99-7427, Installation Instructions, Page: 4 / 4

Share
Download
Metra Electronics 99-7427 Installation Instructions Download Page 4

METRA.  The World’s best kits.

™

metraonline.com

© COPYRIGHT 2004-2015  METRA ELECTRONICS CORPORATION

REV

. 7/16/2015   INST99-7427

K

NOWLEDGE IS 

P

OWER

E

nhance your installation and fabrication skills by 

enrolling in the most recognized and respected 
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call 
800-354-6782 for more information and take steps 
toward a better tomorrow.

Metra recommends MECP 
certified technicians

Installation instructions for part 99-7427

IMPORTANT

If you are having difficulties with the 
installation of this product, please call our 
Tech Support line at 

1-800-253-TECH

. 

Before doing so, look over the instructions a 
second time, and make sure the installation 
was performed exactly as the instructions 
are stated. Please have the vehicle apart 
and ready to perform troubleshooting steps 
before calling.

Summary of Contents for 99-7427

Page 1: ...he on position or the vehicle running It would be best to remove the key from the ignition and then wait a few seconds before removing the factory radio DIN Radio Provision With Pocket ISO DIN Radio Provision With Pocket PAINTED TO MATCH FACTORY DASH 99 7427B BLACK 99 7427G GRAY Textured To Match Factory Dash A Radio Housing B Trim Plate C ISO Brackets D Module Brackets E 2 Phillips Head Screws KI...

Page 2: ... 1 Torx head screw from each side of the module below the radio and then remove the radio and module Retain the module and 2 screws for re use during kit assembly Figure D Continue to kit preparation Dash Disassembly Kit Preparation Figure C 1 Attach the module brackets to the radio housing using 2 Phillips head screws supplied Figure A 2 Secure the module to the completed assembly using 2 factory...

Page 3: ...new radio assembly into the dash and reassemble the dash in reverse order of disassembly ISO DIN radio provision with pocket 1 Remove the metal DIN sleeve and trim ring from the aftermarket radio 2 Mount the ISO brackets to the radio using screws supplied with the radio Figure A 3 Slide the completed assembly into the Radio Housing until it clicks in Figure B 4 Snap the Trim Plate onto the front o...

Page 4: ...ll 800 354 6782 for more information and take steps toward a better tomorrow Metra recommends MECP certified technicians Installation instructions for part 99 7427 IMPORTANT If you are having difficulties with the installation of this product please call our Tech Support line at 1 800 253 TECH Before doing so look over the instructions a second time and make sure the installation was performed exa...

Reviews:

No comments