Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the light switch knob and unscrew the
surrounding trim. Remove the cupholder
and the screws exposed in the cupholder
cavity. Unsnap the (2) trim bezel inserts and
remove the screws exposed. Remove the
lower steering column trim panel and unclip
the dash trim bezel. Using Metra's
86-5618,
pull the factory head unit from the dash and
disconnect the wiring.
1
FORD Econoline 1992-96
2
6
15
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(3) screws from the lower edge of the dash
trim bezel. Remove (2) screws above the
radio opening. Unsnap the right corner of
the dash trim bezel, disconnect the cigarette
lighter wiring and remove the bezel.
Remove the screws securing the factory
head unit and disconnect the wiring.
1
FORD Econoline 1975-91
2
Cut and remove all mounting tabs on
Radio
Housing #2
EXCEPT tabs
"B".
The
mounting tabs can be identified by the
stamped letter on the back of each tab.
Skip
to the Installation Instructions for ALL
VEHICLES on Page #21.
Cut and remove all mounting tabs on
Radio
Housing #2.
The mounting tabs can be
identified by the stamped letter on the back
of each tab. Slide
Bracket Set #1
into the
slots on the sides of the Housing.
Skip to the
Installation Instructions for ALL VEHICLES
on Page #21.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using
Metra's
86-5618,
pull the factory head unit
from the dash and disconnect the wiring.
1
LINCOLN Continental 1988-94 / Mark VII 1990-92
Town Car 1990-94
2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(6) Phillips screws from the face of the dash
trim bezel. Remove the bezel. Remove (2)
screws securing the factory head unit and
disconnect the wiring.
1
JEEP Wrangler 1986-96
2
"B"
Cut and remove the shaft supports from the
Faceplate.
Skip to step #3c in the
Installation Instructions for ALL VEHICLES
on Page #22.
Cut and remove the shaft supports from the
Faceplate.
Skip to step #3c in the
Installation Instructions for ALL VEHICLES
on Page #22.