95-3003G
(Figure A)
Kit Assembly
Kit Preparation
ISO DDIN radio provision
1.
Attach the
radio brackets
to the
radio using the screws supplied
with the radio.
2.
Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS.
3.
After all connections are made,
slide the radio into the dash until
the brackets click in.
4.
Snap the
ISO DDIN trim plate
onto
the factory dash panel.
5.
Reassemble the dash in reverse
order of disassembly.
1.
Snap the
ISO DDIN trim plate
onto
the dash panel and mark the inside
area to be cut with a pencil.
(Figure A)
2.
Remove the
ISO DDIN trim plate
,
then cut the areas marked out in
the previous step.
3.
Cut and remove the radio rear
support from the dash cavity.
Continue to kit assembly
3
