REV. 11/1/2019 INST108-FD7B
KIT ASSEMBLY
3
Note:
For steps 1 and 2, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1.
Secure the
radio brackets
to the radio
chassis using (4) screws supplied with
the radio. (Figure A)
2.
Secure the radio display to the
radio
brackets
using (4) screws supplied with
the radio. (Figure B)
3.
Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Test the radio for proper
operation.
(Figure B)
(Figure A)
(Figure C)
4.
Slightly unclip the middle ac vent panels
in preparation for the next step.
5.
Remove (4) screws in the dash cavity,
then secure the completed assembly
into the dash using those screws.
(Figure C)
6.
Clip the ac vent panels back in.
7.
Snap the
radio trim panel
over the
completed assembly, then reassemble
the dash in reverse order of disassembly
to complete the installation.
