EN
page 33
USER SECTION
5.5
Compliance with hygiene regulations and H.A.C.C.P.
• The machines are equipped with a temperature indicator (chap. 4) which lights up when the
boiler and the tub have reached the preset temperature (values set by the manufacturer).
It is recommended to wait for this light to go on before starting the next cycle.
• Scrape food from the dishes carefully in order not to clog the filters, nozzles and pipes.
• Unload the wash tub and clean the filters at least twice a day.
• Check that the amount of detergent and rinse aid dispensed is correct (as suggested by
the supplier). In the morning before starting up the machine, check that there is enough
product in the containers for daily use.
• Always clean the support floor of the dishes.
• Remove the rack from the dishwasher with clean hands or gloves so as not to dirty the
cutlery.
• do not dry or polish the dishes with non-sterilized cloths, brushes, or dusters.
5.4
Regeneration device (optional)
Resin regeneration by the water softener is very important. Resin regeneration: resin rege-
neration should be carried out according to the number of cycles as indicated in the picture
below. Ex. 27°f (or 15°D)= 39 cycles.
To carry out the purifying cycle, follow these instructions:
• Turn the main switch 1 (see chap. 4) to 1 (OFF).
• Open the door.
• Remove the overflow tube and empty all the water in the tub.
• Check and fully replenish the salt, being careful not to spill it into the tub. A strong
concentration of salt can negatively affect the correct functioning and service life of the
machine.Fill the special container, placed on the inside of the tub, (see pict. 6) with coarse
salt (1-2 mm. grains).
• Switch the machine on.
• Close the door,press button 4 (see chap. 4) for 5 seconds and wait for the turn on of the
indicator light (d) (see chap. 4). The indicator light (d) will come on when the cycle is
activated. The resins contained in the purifier will be automatically regenerated in about
20 minutes. The cycle is completed when the indicator light (d) goes off.
After the softening cycle, switch the machine off.
P.S.: once the cycle has begun it cannot be stopped.
If a water conditioner is installed externally, follow the instructions given in the relative
manual to regenerate the resins.
• The flashing of the cycle lamp during the softening cycle, indicates a malfunction or a
missed draining of the wash-tank (see chapter 7).
In the case of water hardness above 35°f it is advisable to install an
external water softener.
SAL
T
pict. 6
