18.9.2007
Rev. 2.4
Installation
7
5.
Installation
5.1
General
The crushed ice maker is delivered attached to a special wooden pallet and protected with
cardboard packaging.
Installation must be carried out exclusively by qualified and authorized staff, in compli-
ance with current national standards and following the manufacturer’s instructions.
5.1.1
Using conditions
The best performance of the crushed ice maker is achieved at a room temperature of be-
tween 15ºC and 35ºC and a water supply temperature of between 15ºC and 25ºC. Avoid
installing the appliance where it may be exposed to direct sunlight or near to heat sources,
such as radiators, stoves, dish-washers, etc.
This appliance must not be used outside, must not be installed in damp places or where it
is liable to be sprayed with water. The appliance must be positioned at a distance of at least
5 cm from the side walls.
5.2
Possible disturbances from environment (to environment)
If installation is carried out incorrectly, damage and/or injury may ensue to the environ-
ment, persons, animals or things. The manufacturer declines all responsibility for any
such damage or injury.
5.3
Storage
The net weight and the weight including packaging of the crushed ice maker are given on
the cover of the packaging. In order to prevent the oil contained in the compressor from
flowing into the coolant circuit, make sure to transport, store, and handle the crushed ice
maker always keeping it standing upright. Follow the instructions given on the packaging.
5.4
Preparing installation
Make sure, that the crushed ice maker will be installed on an perfectly level. Avoid in-
stalling the appliance near heat sources. A floor drain should be found near of the place
of installation. The maximum distance being 5 m. Make sure that the meltwater pipe
presents a slope of at least 5 % throughout its entire length.
