iBCN – User Manual
TD 13 – 053
31
It is highly recommended in all cases that these batteries
be accessed and changed through the bottom end of the
beacon. Install fresh batteries with the positive terminal
towards the head assembly as shown in
. Please
ensure that the insulating plastic tube remains within the
pressure case during installation.
NOTE 1:
Cycling power to the head assembly will
result in the device defaulting to the ON state, unless
the Magnet is attached
NOTE 2:
Following disconnection of the head
assembly from the batteries, wait for a period of two
minutes before reconnecting. This period of time is
required to let the circuit fully discharge and ensures
that the device will function optimally.
Figure 10: Bottom End Caps Removed For Battery Change
Summary of Contents for MMI-513-00000
Page 2: ......