Faceplate
O-ring
Half Dome
Lever Handle
Screws
Body assembly
Cardboard sleeve
Apply silicon
sealant
Wall
1.
2.
3.
5.
6.
Distance from mounting
stud to front of lining: 57-68mm
Hole cutout 57mm
4.
IMPORTANT
Please read all of the instructions before installation
Avoid restrictive piping, fittings or sharp angled bends when plumbing the mixer.
Do not hydrostatic test the installation with this mixer installed. Damage to the ceramic
headworks may occur.
All pipe-work must be thoroughly flushed prior to installation of the mixer. In-line filters must
be installed on both hot and cold supplies to prevent foreign particles damaging the ceramic
headworks.
NOTE: It is the responsibility of the installer to ensure a water proof seal is achieved
between the faceplate and finished surface of the wall. If in any doubt about the quality
of the seal the faceplate should be removed and then reinstalled using silicon to ensure a
seal is achieved.
Hot
Cold
