6
3
Please keep these instructions for future reference and request of replacement
parts
General Safety Information
Please read all of the instructions before installation.
Methven recommends this product is installed by a competent person in
compliance with all relevant regional regulations.
Remove all packaging and check the components for damage before starting
installation.
This product must not be modified in any way as this will invalidate the guarantee.
It is the responsibility of the installer to ensure a waterproof seal is achieved, after
installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe
temperature as per regional regulations.
Line Drawing
Installation Requirements
Before commencing installation of the new product, ensure that the system has
been flushed to remove any debris, which could cause damage to the valves and
invalidate the warranty.
Installation
1, Screw the threaded fixing bolt into the bottom of the mixer body
2, Screw both
Flexi
Tails into the tap body, ensuring that the O-Ring on the
tail is positioned inside the tap body. Hand tighten, do not use PTFE tape or
similar to create the seal.
3, Offer the tap up to the hole in the sink
4, On the underside of the sink fit the
rubber and metal horseshoe shaped
washers onto the threaded fixing bolt and
using the nut provided tighten until the
tap is secure in the mounting hole.
Note:
Plastic Triangle -
If required a under
sink mounting triangle can be purchased,
this should be used on thin work surfaces
to help distribute the weight of the tap
and provide a thicker mounting surface
for the fixing kit to clamp to.
5, Connect the
male en
d of the tail to the
corresponding hot and cold inlets
.
6, Reinstate water supply and test for
leaks.
