Nipple
Nut
Spout Elbow
Pitch Plate
Shower Body
Tiling Guide
Faceplate Foam Seal
Faceplate
Hex Screw
Cap
Handle
Hex Screw
Aerator
Spout O-ring
Spout Adapter
Spout
IMPORTANT:
Please read all of the instructions before installation.
General:
•
•
•
•
•
•
•
•
•
Methven recommends this product is installed by a licensed plumber in compliance with
all relevant regional regulations.
Do not hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
Do not remove the ceramic cartridge from the mixer when installing.
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as
per regional regulations.
This mixer is not recommended for use in uncontrolled heating systems such as wet-backs
or solar heating units unless a suitable tempering valve is fitted.
If limited water flow is experienced, locate aerator and filter washers and clean away
foreign material as required.
It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the
product and reinstall.
IMPORTANT:
Before you begin, turn off the water supply.
Installation:
100
38mm
MIN Ø 55mm
Ø 30mm
MAX Ø 70mm
Step 1
Fit pipework to inlet ports on the shower body before
securing to the support timber. Installation Depth,
ID= 60±10mm
. This is defined as the distance between
the mounting surface and the finished wall surface.
Secure the mixer body and then the spout elbow on to
the supporting timber ensuring that it is oriented
square and vertical. Use a spirit level on the front face
and top edge of the pitch plate to ensure that the
assembly is square in all directions.
Step 2
Flush all pipe-work prior to the next step.
Connect mixer body to hot and cold supplies and outlet
to the spout elbow ensuring a good seal at each joint.
Remove pitch plate and discard. Remove and refit
all-thread nipple to spout elbow using plumber’s tape
to ensure a good seal. Replace plastic cover on
all-thread nipple.
Step 3
Wall lining should be finished as per the diagram on the
right.
Use silicone to seal around the body cover of the mixer
to the finished wall lining and refit plastic covers.
Step 4
Remove plastic covers and discard.
Cut all-thread nipple to
15±2mm
from finished wall
surface.
Screw spout adapter onto all-thread nipple using
plumber’s tape to ensure a good seal.
Stick self-adhesive foam seal to perimeter of back of
faceplate ensuring that there is a gap at the bottom.
Wet rubber seals or grommets and slide faceplate onto
shower body and over spout adapter.
Ensure spout O-ring is in place and push spout onto
adapter. Tighten hex screws to secure in place using the
2.5mm hex key provided.
Push handle onto cartridge pin, tighten hex screw and
cap the hex screw hole with the chrome cover.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Aerator
Key
Hex Key
ID= 60 ±10mm
