Metertech 475101, Operational Manual

Page: 15 / 18

12
4-5 Print Function
01 Press SEL/ESC button four times from display “SYSTEM MENU,1:ABS MODE”.
02 LCD displays “SYSTEM MENU,5:PRINT”.
03 Press READ/ENTER button, LCD will sequentially display
125 sets of stored data with the
form “XXX X.XXXABS MX”.
04 Press READ/ENTER button, LCD will stay at one reading.
05
Press READ/ENTER button again, LCD will continue update new reading to the final
reading. Press SEL/ESC button, the display will go back to “SYSTEM MENU, 1:ABS
MODE”.
06 If the printer is already connected to the machine, all the data will be printed out.
Note: If printer is connected to the machine while operating at above any mode,
the displayed blank data, sample data and standard data will also be printed.
4-6 RS-232 Function
01 Press SEL/ESC button five times from display “SYSTEM MENU,1:ABS MODE”.
02 LCD displays “SYSTEM MENU,6:RS232”
03 Connect PC COM port to the machine serial port through RS-232 cable.
04 Press READ/ENTER button, LCD displays “RS232, M6----- PC”. The machine is waiting for,
accepting and executing PC command such that the stored data is transmitted to PC. After
finishing this work, press SEL/ESC button to return to main menu.
4-7 ABS Calibration Function
01 Press SEL/ESC button six times from display “SYSTEM MENU, 1:ABS MODE”.
02 LCD display “SYSTEM MENU, 7:CALIBRATION”.
03 Press READ/ENTER button, LCD displays “ABS CALIBRATION, COEFF=1.000”.
04 Press READ/ENTER button, LCD displays “ABS CALIBRATION, 1:KEY IN COEFF”. User can press
SEL/ESC button to select “1:KEY IN COEFF” by following step 05 , or “2:READ STANDARD”
following step 06.
05 Press READ/ENTER button, LCD displays “KEY IN COEFF, COEFF= 1.000”. Key in coefficient
value as instructed in Section 3-3-** . Press SEL/ESC button to go back to SYSTEM MENU.
06 Press READ/ENTER button, LCD displays “KEY IN STANDARD, ABS=0.000”. Key in standard ABS
value as instructed in Section 3-3-** .
07 Press READ/ENTER button, LCD displays “CALIBRATION, READ BLANK”. Insert the blank
well or place the blank cuvette into the read position.
08 Press READ/ENTER button, and LCD displays “00 0.000ABS, READ STANDARD”.
09 Push the standard well or place the standard cuvette into the read position.
10 Press READ/ENTER button, and LCD displays “ABS CALIBRATION, COEFF=X.XXX”. Press
SEL/ESC button and go back to SYSTEM MENU.
Note: The default coefficient value is 1.000, and any change through above steps
will be saved in memory. The coefficient is used as a multiplier for all ABS
reading of four measurement modes. Measurement errors can be reduced by
this calibration procedure.