M8 connector
from sensor
Mounting post
Mounting clamp
AROYA
Sensor Nose
Antenna
Mounting ar
m
1. Mount the Arm
Unscrew the mounting arm clamp
and slide the mounting arm
onto the mounting post over the
canopy in the desired location.
The clamp will accommodate pipe
sizes of 0.5 to 1.0 in.
Hand-tighten the screw until the
mounting arm is secure.
Installation
AROYA QUANTUM SENSOR KIT QUICK START
Preparation
Confirm that the Apogee Quantum PAR/PPFD sensor, AROYA Sensor
Nose, and AROYA Mounting Arm arrive assembled and intact. Prior
to installation, identify and set up the desired mounting location for
the AROYA Mounting Arm.
2. Check Sensor Operation
Log into the AROYA software or
mobile app.
Go to the
Devices page. A check
mark next to the sensor indicates
it is connected to the internet.
Select the room where the device is
located and assign it to that room.
New sensor data is automatically
uploaded every 3 min.
18452-00
4.5.2021
ATTENTION
For best results, use the latest versions of software for the
computer or mobile device.
AROYA System
This quick start is to add a single type of sensor into the larger
AROYA monitoring system. Follow the instructions in the
to set up the AROYA system prior to using
this quick start. The AROYA Sensor Nose must be assigned in
AROYA software before it can relay and record Quantum sensor
measurements.
Read the AROYA Hardware Quick Start and full AROYA manual at
.