1018 -
IP65 INSTRUCTION MANUAL
INTRODUCTION:
The entire staff of Meteor would like to thank you for selecting the
1018
(IP-65)
LUMENATOR
as your fixture of choice. We have
expended that extra effort to make sure you are more then pleased
and satisfied with your purchase.
Please check and make notice of any external cosmetic box damage
caused by transportation. Notify your dealer
– he in turn will notify us.
If there is any damage
– either inside the box or outside the box –
DO NOT INSTALL THE DEVICE. There is a possibility that
something may have come undone or unplugged.
Unpack the Lumenator. Inside the box
– you should find:
- Protective packing
- The Lumenator
- One power cable
- One XLR cable
- Instruction manual
DESCRIPTION:
FEATURES:
-
16
BIT DIMMING
-
OVER TEMPERATURE Protection
-
Can set DMX Address via Controller
-
4, 6 or 9 DMX channels selectable for numerous
applications.
-
Automatic Identify Master Signal and change to
Slave mode.
-
Step-less RGBW COLOR mixing
-
Color CALIBRATE function
-
Equipped with 18 - 10w LEDS (4 in 1)
-
Switch-mode power supply
– 90v-240v AC.
SAFETY INSTRUCTIONS:
This lighting fixture has left our factory in perfect condition. In order to
maintain this condition and to ensure safe operation, it is absolutely
necessary for the user to follow the instructions and caution notes written in
this user manual.
This fixture falls under protection-class 1. Therefore it is essential that the
device should be grounded.
111111
MAKE SURE TO PRESS
11t11THE
MIDI/ADD BUTTON AFTER
A qualified person must carry out the Electrical connection (to power). If the
external “flexible” cable or power cord of this fixture is damaged, it HAS to
be and will be replaced by the manufacturer or service agent or a similarly
qualified person in order to avoid hazard or electrical shock.
Make sure that the available voltage is NOT higher than stated at the end of
this instruction guide / manual.
Make sure the power cord is NEVER “crimped” or damaged by sharp edges.
If it is
– replacing a cable must be done by an authorized dealer trained in
electrical repair.
Always disconnect from electrical MAINS, when the
1018
Lumenator
is NOT
in use or before cleaning it. Definitely before cleaning it.
You could wind up getting a severe electrical shock.
Only handle power cord by the PLUG.
Never PULL out the plug by tugging on the power cord.
Very strong possibility of getting serious electrical shock.
NEVER LOOK DIRECTLY INTO THE LIGHT FIXTURE WHILE IT IS
POWERED UP
– SENSITIVE PEOPLE MAY SUFFER FROM EPILECTIC
SHOCK (far fetched) BUT IT COULD HAPPEN.
IMPORTANT
:
Damage caused by the disregard of this user manual IS NOT SUBJECT TO
WARRANTY. The
DEALER
is not and will not ACCEPT LIABILITY for any
resulting defects or problems caused by not following instructions.
IGNORANCE is NOT A VALID WARRANTY ISSUE.
*** PLEASE MAKE NOTE
:
The power cord has been deliberately left OFF as most IP65 FIXTURES
ARE USED OUTSIDE and are usually hardwired into APPROVED
OUTSIDE WEATHER-PROOF JUNCTION BOXES.
Do not plug into standard unprotected outlet, except for test purposes.
2
Summary of Contents for Lumenator 1018
Page 5: ......
