Installation manual REV:201107
BREAK-TWA
Twisted Wire Audio System
www.metel.eu
3/6
Installation and Setting
1.) Mounting of converters
MIC – screw the microphone to surface using the slot at the backside. We recommend to install the microphones
with 20°- 90° slope in the outdoor (raining) conditions.
RX8 – patch panel for mounting into 19˝ frame.
TX – small BOX design, also suitable for installation to camera covers
RX – BOX design, mounting on flat surface
2.) Connection of supply and signal wires
Connect supply and signal wires according to the pictures below.
GAIN
MIN
MAX
P
IN
K
R
E
D
Y
E
LL
O
W
G
R
E
E
N
BREAK-TWA-RX8-UNIT SUPPLY
REAR VIEW
MIC-BIAS output
On the MIC-BIAS output is
connected rectified and
nonstabilized voltage from
the RX8 SUPPLY clamps.
Maximum recommended
length between receiver
and the powered
microphone is 300m for
12-16VDC SUPPLY voltages.
30 cm
BREAK-TWA-TX SUPPLY
POWER LED
INDICATION
AUDIO INPUT CINCH
TWIST OUTPUT
POWER SUPPLY 10-16VDC
POWER SUPPLY
10-30V AC/DC
20 - 90
o
o
INTERNAL SUPPLY 10-16VDC FOR
BREAK-TWA-MIC
Twisted pair transmitter TWA-Tx is designed for transmission of audio signal over UTP to the distance of max. 1 km.
TWA-Tx is already integrated in TWA-MIC/12-24 microphone.
T
W
A
-T
X
G
N
D
+
1
2
V
D
C
A
U
D
IO
I
N
T
W
IS
T
+
T
W
IS
T
-