
5
Installation
Unpacking
Unpack the peeler immediately after receipt. Please inspect the peeler to ensure there is no damage and
that all parts are included i.e. water inlet, rubber lid etc. If the machine is found to be damaged, keep all
the packaging and contact us, or your supplier of the equipment, immediately.
You should receive with your peeler:
1 x Water Inlet Nozzle
2 x Lifting Hook
1 x Instruction Manual
If any of the above items were not received with your peeler, please refer to page 9 for contact details
and inform us immediately for replacements.
The machine should be secured to the floor before first use.
Water Supply Connection
The water inlet nozzle connector is supplied and should be fitted to the outside
of the machine facing upwards. It has two possible inlet locations, one on either
side of the machine, whichever is more convenient for your installation.
1.
Thread the water inlet valve (1) onto the elbow joint (2), ensuring a fibre
washer (4) is placed between the two.
Ensure the valve is tightened securely to eliminate leakages
.
2.
Take the water inlet bush (3) with a fibre washer (4) placed over it and feed
through the chamber wall from the inside.
3.
Place another fibre washer (4) onto the water inlet bush on the exterior side of the chamber. Take
the assembly from step 1 and thread the remaining elbow joint opening onto the water inlet bush.
Ensure the assembly is tightened securely to eliminate leakages. Also ensure the water inlet
valve is pointing directly upwards, otherwise the air gap does not function correctly.
Connect the water supply pipe to the water inlet, connect the other end of the supply pipe to a cold water
tap or shut off valve that can be used to supply a sufficient water flow into the machine.
1
3
4
2
Summary of Contents for GU4
Page 2: ...1...