11
Sharpen the blade on models AUT.300 – AUT.350
Blade grinding must be carried out as soon
as a decrease in cutting capacity is
noticed.
Proceed as follows:
•
Check that the slicer is properly
connected to the electrical line and
that the slice thickness regulator is
positioned on “0” (must be ON the
light of OFF button);
•
Turn the function mode selector knob
(11)
counterclockwise
(manual
mode);
•
Loosen (do not remove) the locking
knob (3) of the grinding device;
•
Lift up it as shown in the figure and
rotate it at 180°;
•
Reposition it in its housing and relock
the knob (3);
•
Start the blade pressing ON button;
•
Sharpen the blade by pressing and
holding down the grinding wheel
button (4) for about 10 seconds;
•
Press and hold down the button of the
trimming wheel (5) for about 2-3
seconds;
WARNING: do not trim too much so as
to avoid twisting the blade edge.
•
Stop the blade movement pressing ON
button;
•
Loosen the locking knob (3);
•
Raise and rotate the grinding group
clockwise by 180° and then reposition
it in its housing;
•
Screw the knob back (3);
•
Clean the slicing machine.
