14
ENG
P L E A S E R E A D T H E M A N U A L C A R E F U L LY T O AV O I D D I F F I C U L -
T I E S D U R I N G T H E I N S TA L L AT I O N P R O C E S S .
Faucet parts
(picture 2)
1. Seal
2. Tightening screw
3. Rubber crescent
4. Metal crescent
5. Screw nut
6. Flexible hos
7. Base ring
Tools and materials
(picture 1)
19. Wrench
20. Crew driver
21. Seal
22. Putty
Test after the installation
MAINTENANCE INSTRUCTIONS
BLUE - short hose, connection to the main water supplying system
RED - long hose, connect to the red pipe( hot water) on the boiler
BLUE - long hose, connect to the plue pipe( cold water) on the boiler
STEP 2 (picture. 4)
STEP 3
Check that all connections are tightened firmly
Remove the aerator unscrewing it counter clockwise
Put the lever to the position OPEN
Open the angle valve to check that no connection leaks
Let the water run for a minute in order to eliminate the dirt that
might be in the system
Check again there are no leaks, and close the valve
Clean the aerator and install it back again.
Product maintenance:
Wipe with a damp cloth.
Use mild household cleanser.
Do not use strong acid or abrasive cleaners. After cleaning , dry faucet using a soft cloth.
Product characteristics:
This product is casted out from a high quality brass, protected by advance technological process and was strictly inspected in
order to maintain its high quality during the years of use.
Suitable for normal temperatures between: 5-90 °C
Suitable for normal water pressure: 1-8 bar ( 0.1-0.8 MPa).
It has different hoses for hot and cold water.
While an electrical water heater connected to the three hoses mixer is turned on, dripping from the sink mixer is
expected
STEP 1A
- Installation of the single lever mixer with two hoses
(pic. 3)
STEP 1B
- Installation of the single lever mixer with three hoses
INSTALLATION MANUAL
8. Seal
9. Screw pipe
10. Rubber ring
11. Screw nut
12. Flexible hose
13. Seal
14. Tightening screw
15. Rubber crescent
16. Metal crescent
17. Screw nut
18. Flexible hose
A
C
B