Metal-Fach T703A, Instruction Manual

Page: 49 / 64

INSTRUCTION MANUAL – T703A FARMING TRUCK TRAILER
49
2. Check nuts and bolts on a regular basis at their fixed positions, and tighten. Replace
regular screws only with screws of the same quality and strength as the original ones
(see item 6.5).
3. When performing service works under a raised and tilted but unloaded Trailer's body,
always secure the body against dropping using the support which is included as an
accessory with the Trailer.
4. When replacing parts, use suitable tools and protective gloves.
5. Clean the Trailer thoroughly after you finish work, and do not leave any residual load
carried on the Trailer's body.
6. Disconnect the continuous power supply before welding and working on the electrical
system.
7. Protective equipment is subject to wear and tear. Therefore, it should be adjusted,
inspected, and replaced in good time, on a regular basis.
8. The spray-suppression skirts must be cleaned on a regular basis.
9. Use only the spare parts recommended by “METAL- FACH” Sp. z o.o. in Sokółka.
10. The Trailer must be stored in roofed areas (preferably on a level and hard surface) and
in such a way as to prevent any injury to people and animals.
11. Used parts must be handed over to the appropriate recycling centres subject to the
environmental requirements.
Repair instructions
When carrying out minor repairs caused by accidental defects, maintain the proper
cleanness and ensure all parts are correctly mounted in their places, when making the required
adjustments necessary for the proper functioning of the Trailer.
Minor repairs during operation (in the field) must be carried out on site by the operator.
Store parts disassembled during repair and protect them against dust and other
contaminants. Special attention must be paid to the protection and cleanness of the bearings.
During any field repairs, maintain the proper cleanness of the parts to be fitted,
especially the parts which you drop to the ground, which should be washed or at least cleaned
of any dirt to a degree which ensures proper functioning.
Observes a series of technical rules corresponding to the disassembly and assembly
of parts and components, when carrying on-going repairs and overhauls, thus ensuring the
quality and efficiency of work.
After each repair of the Trailer's subassemblies, check that they are working properly.
When carrying out maintenance and repair work, wear suitable protective clothing,
including gloves, footwear, and goggles. It is essential to use the appropriate tools. Observe
the generally accepted rules of work health and safety when working.
In the event of injury, rinse, and disinfect any wound, and, in the case of serious injuries, seek
medical advice.
When carrying out repair work that involves welding, pay special attention to the
flammable or fusible components. If they are susceptible to ignition or damage, they must be
dismantled or covered with non-combustible material before starting welding. Before starting
any work, it is advisable to have a CO
2
or foam extinguisher ready at hand.