Metabo LF 724 S, Original Instructions Manual

Page: 10 / 80

ENGLISH en
10
Reduce dust exposure:
Some dust created by using this power tool
may contain chemicals known to cause
cancer, allergic reaction, respiratory disease, birth
defects or other reproductive harm. Some
examples of such substances are, lead (in paint
containing lead), additives used for wood treatment
(chromate, wood preservatives), some wood types
(such as oak or beech dust).
The risk from these exposures depends on how
long you or bystanders are being exposed.
Do not let particles enter the body.
To reduce your exposure to these chemicals: work
in a well ventilated area, and work with approved
safety equipment, such as dust masks that are
specially designed to filter out microscopic
particles.
Observe the relevant guidelines for your material,
staff, application and place of application (e.g.
occupational health and safety regulations,
disposal).
Collect the generated particles at the source, avoid
deposits in the surrounding area.
Use a suitable extraction unit.
Reduce dust exposure with the following measures:
- Use an extraction unit and/or air purifiers
- Ensure good ventilation of the workplace and
keep clean using a vacuum cleaner Sweeping or
blowing stirs up dust
- Vacuum or wash the protective clothing Do not
blow, beat or brush
See page 2.
1 Protective flap
2 Locking button
3 Additional handle
4 Sliding switch ( 0 / I )
5 Handle
6 Extraction nozzle
7 Extraction connection piece (Ø 35 mm)
8 Graver
9 Multi-socket spanner
a Hexagon
b Torx
10 Planing base
11 Reversible blade
Before plugging in, check that the rated mains
voltage and mains frequency, as stated on the
rating label, match with your power supply.
Always install an RCD with a max. trip current
of 30 mA upstream.
6.1 Attaching the additional handle
Always work with the additional handle (3)
attached! Attach the auxiliary handle as
shown.
Always work with an extraction
system to guarantee perfect
machine operation.
Always guide the machine with both hands on
the handles (3), (5) provided.
7.1 Switching On and Off the paint remover
Switching on
Lift paint remover so that the cutter head is free.
Push the slide switch (4) forward.
I On
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
Switching off
Lift paint remover so that the cutter head is free.
Press the rear of the slide switch (4). The slide
switch jumps back.
0 Off
Wait until the cutter head is at a standstill
before setting down the machine. An exposed
cutter head can get caught on the surface and lead
to a loss of control and possible serious injury.
7.2 Locking the cutter head
Danger of injury from the sharp edges of the
reversible blades. Lock the cutter head only
when the cutter head is idle! Switch off paint
remover and pull the mains plug from the socket!
Lay the paint remover on its side.
Press the locking button (2) up to the stop and keep
pressed.
Simultaneously turn the cutter head using the
hexagonal wrench (9-a) (any direction). Turn until
the pressed locking button noticeably engages and
the cutter head is locked.
5. Overview
6. Commissioning
7. Use