7.2
Installation
The machine must be installed on a firm and level floor. Adjust feet
until planing beds are level. All four feet must evenly rest on the floor
to prevent rocking.
7.3
Connection to Power Mains
- Check if voltage of power mains matches with voltage stated on machine’s type plate (400 V 50 Hz
±
5%).
- This machine must be operated on a residual current device (RCD) of 30 mA capacity , having a fault current
breaker.
- The outlet this machine is connected to must be earthed and each phase protected by a 16 A time-lag fuse
or circuit breaker. A minimum conductor crossection of 2.5 mm
2
is required.
- This machine must be safety earthed. The yellow/green lead is the earth conductor. If a plug matching your
local standard outlet is fitted to the power cable, do not connect the earth lead to one of the current conducting
leads.
- Do not operate this machine with a damaged power cable. Risk of electrical shock.
- Worn or defective cables must be replaced immediately. Have replaced by a qualified electrician only.
7.4
Direction of Rotation
Important!
The direction of rotation of the cutterblock must be
against the feed direction. It is factory set on single-phase machines.
On machines equipped with a three-phase motor, start machine
briefly to check direction of rotation. To change, turn phase inverter
pins in plug by 180
°
with screwdriver.
7.5
Dust Collection
If this machine is operated indoors for more than 30 minutes a day it must be connected to a dust collector (the
dust of oak and beech is classified as cancer causing). The dust collector this machine is connected to must
provide for a minimum air flow rate of 16 mtr/sec.
The dust collection port of the dust chute has a nominal diameter of 100 mm.
7.6
Automatic Dust Collector Starting
The electrical connection of this machine must ensure that a dust collector connected to it automatically starts
when the machine is switched on, and provide for 20 sec post-running of the dust collector after the machine
is switched off.
8
Safety
- Adhere to the instructions, the safety rules in particular.
- Disconnect from power (pull plug form outlet) before servicing.
- Check guards
daily
as per para. 14 of this manual.
- Never reach into feed openings while machine is running. Observe warning label with crossed-out hand on
machine, indicating the danger (see also above).
- Follow instructions for fence and guard setting (para. 12.4 and 12.6).
- Do not use planer blades of less than 22 mm width.
- Dust collection as per para. 7.5 of this manual must be provided for.
- Do not work stock larger than the max. workpiece dimensions as per para. 9.
- Never operate machine without cutterblock guard in place.
- Replace damaged parts and safety guards at once with genuine metabo parts.
- Person under the age of 16 are not permitted to operate this machine.
- In case of disturbances always let the cutterblock come to a complete standstill before checking the machine.
- Always have guard and fence set for the job on hand.
Summary of Contents for HC 410
Page 2: ......
