Metabo BHE 22, Operating Instructions Manual, Page: 9 / 28

9
ner
rd
de
ent
ole
r
s
act.
th
he
d
Metabo’s packaging can be 100% recycled.
Worn out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
P
1
=rated input
P
2
=rated output
n
1
= no-load speed
n
2
=load speed
ø max = max. solid drill diameter
s max = max. impact rate
W = single impact strength
m = weight
D = spindle collar diameter
b = drill chuck chucking capacity
Typical A-weighted sound levels:
L
pA
= sound pressure level
L
WA
= sound power level
During operation, the acoustic level may
exceed 85 dB(A).
Wear hearing protection!
ahw = typical weighted acceleration in the
hand-arm area
Measured values established according to EN
50144.
The stated technical specifications are subject to
tolerances (as specified in the respective current
standards).
15 Environmetal Protection
16 Technical Specifications
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
power tool.
14 Repairs
If the trigger (14) can not be depressed, check to
see that the direction of rotation selector switch
(12) is fully set to the R or L position.
Electronic signal indicator (9) with VTC
electronics
(BHE 24, KHE 24, KHE 28)
Rapid flashing - restart protection
When power is restored after a power supply
failure, for reasons of safety the still switched-on
machine will not start. To continue operation
switch the machine off, then on again.
Slow flashing - carbon brushes worn
The carbon brushes are almost completely worn. If
the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorized service centre.
f
Use only genuine Metabo accessories.
If you need accessories, check with your dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4.
A Tools with SDS-Plus shank
B Twist drills for metal and wood
C TCT core cutter
D Dust extraction kit
12 Trouble Shooting
13 Accessories
(BHE 26, KHE 26, KHE 28)
E CODE! Key
1 BHE22 ENG_0706 16.09.2008 14:08 Uhr Seite 9