Metabo BE 4006 -, Original Instructions Manual

Page: 7 / 52

ENGLISH en
7
Original instructions
We, being solely responsible, hereby declare that
these drills conform to the standards and directives
specified on page 3.
The machine is suitable for drilling in metal, wood,
plastic and similar materials as well as for
screwdriving.
The user bears sole responsibility for damage
caused by improper use.
Generally accepted accident prevention
regulations and the enclosed safety information
must be observed.
For your own protection and for the
protection of your electrical tool, pay
attention to all parts of the text that are
marked with this symbol!
WARNING – Reading the operating instruc-
tions will reduce the risk of injury.
WARNING Read all safety warnings and
instructions. Failure to follow all safety warn-
ings and instructions may result in electric shock,
fire and/or serious injury.
Keep all safety instructions and information for
future reference.
Pass on your electrical tool only together with these
documents.
Always wear hearing protection when using
hammer drills. Exposure to noise can cause loss
of hearing.
Hold the power tool by insulated gripping
surfaces when performing an operation where
the cutting accessory may contact hidden
wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed
metal parts of the power tool "live" and shock the
operator.
Pull the plug out of the plug socket before any
adjustments or servicing are performed.
Take care to avoid gas, electricity, and water
supplies!
Avoid inadvertent starts by always unlocking the
switch when the plug is removed from the mains
socket or in case of a power cut.
Keep hands away from the rotating tool!
Remove chips and similar material only with the
machine at standstill.
Caution must be exercised when driving screws into
hard materials (driving screws with metric or
imperial threads into steel)! The screw head may
break or high reverse torques may build up.
High forces are released if the tool jams or catches.
Always hold the tool firmly, ensure you have good
footing and concentrate when working.
Secure small workpieces. Clamp in a vice for
example.
Do not keep the ventilation slots closed.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory diseases
to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in
conjunction with additives for wood conditioning
(chromate, wood preservative). Material containing
asbestos must only be treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
See page 2.
1 Chuck key (for a geared chuck) *
2 Geared chuck *
3 Keyless chuck Futuro Plus *
4 Rotation selector switch
5 Trigger
6 Locking button (continuous activation)
7 Scaffold hook mounting
8 Scaffold hook *
* depending on equipment
Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match with your
power supply.
To guarantee secure purchase of the
chuck: After initial drilling (clockwise), use a
screwdriver to firmly tighten the safety screw inside
the drill chuck. Caution left-handed thread! (see
Section 8.5)
Fitting scaffold hook (8): Clip into the scaffold
hook mounting (7) and turn until it engages in one of
the four positions.
1. Conformity Declaration
2. Specified Use
3. General Safety Instructions
4. Special Safety Instructions
5. Overview
6. Commissioning