4. Forming resin pipes (Fig. 16)
Use nozzle (curved surface) to evenly heat the
circumference of the resin pipe.
To prevent the inside of the pipe from narrowing when
bending it, etc., pour sand inside, block both ends and
then gently bend it.
Nozzle (Curved surface)
Fig. 16
5. Defrosting water pipes (Fig. 17)
Use nozzle (curved surface) to heat the frozen area
from the edge to the center. Do not mistake gas pipes
for water pipes and heat them.
Take care to avoid damaging frozen resin areas on
water pipes.
Nozzle
(Curved surface)
Fig. 17
WARNING SIGNALS
This product features functions that are designed to
protect the tool itself as well as the battery. If any of the
safeguard functions are triggered during work, the LED
light and the temperature display will blink for a few
seconds as described in Table 7.
When any of the safeguard functions are triggered,
immediately switch o
ff
and follow the instructions
described under corrective action.
Table 7
Safeguard
Function
LED light
Display
Display
Corrective
Action
Overload
Protection
On 0.5 sec./
o
ff
0.5 sec.
Remove the
cause of the
overload.
Temperature
Protection
Allow the tool
and battery
to thoroughly
cool.
18
English
00Book̲RH18DA̲metabo.indb 18
00Book̲RH18DA̲metabo.indb 18
2022/01/26 11:10:22
2022/01/26 11:10:22
