9
17. On/Off :
After turning on the device, the display shows the selected time and the unit is ready
to work. Press the key
twice
and the cleaning will begin. Cleaning will stop when
the time arrives. To stop the device before time runs out, press the key
twice
.
18. Quick time selection key
Press the key
. The display will score
. Each time you press the key, it will increase by 5
minutes.
OPERATION
Remove the lid and hold it in the support. put the items in the basket. Then
put them in the cleaning tank. Add water or a cleaning solution to a level
between
min.
and
max.
and above the area to be cleaned. In order to
prevent scratches and friction of the products, do not pile them up
If the device runs out of water, the energy of the ultrasound will not be
absorbed. This model has a lot of power. In 15 seconds the device can be
damaged or its life can be severely reduced.
Connect the power cord and turn the switch on (I). The display will show
, This is the most commonly used time. If the time needs to be
adjusted, press If the time needs to be adjusted, press Time button and
buttons
and
. The time can be set between 1 to 30 minutes. Common
cleaning time are 5, 10 or 15 minutes. Prolonged cleaning time may result
in:
d. Loosening of the screws if used.
e. Increasing the pre-existing cracks.
f. Peeling of coating which was already separated.
Press
button twice to start cleaning.
During cleaning, buzzing sound can be Heard from the cleaning tank,
indicating the cleaning is underway. Closing the lid will reduce the noise.
LED display will count down to show the remaining cleaning time. When it
displays
, the cleaning is done. To stop cleaning at any time, press
button
twice.
The unit is designed with overheating protection to avoid damage caused by
extended and continuous operation. When the light
is on, the unit will
not turn on even it is forced to. The unit will idle for about 20 minutes. Then
can be restarted after the green light comes on.
