Messtechnik Sachs Irinos IR, User Manual

Page: 112 / 214

112
Irinos IR Users Manual © 2015 - 2016 Messtechnik Sachs GmbH, Germany
Setup
Enumeration process
The duration of the enumeration process depends on the number of
Irinos-Boxes connected. Typically it takes only a few seconds. If
many Irinos-Boxes are used, it may last up to 15s.
Prior to being enumerated, the elements of the 7-digit display
turn clockwise:
Afterwards the Box number is shown in the 7-digit display. An
exception is the first Box having a 7-digit display: it first shows the
IP configuration. Depending on the configuration, this lasts a few
seconds.
Termination
During the enumeration process, the first and the last Irinos-Box of
the ILink cabling are automatically detected and terminated. This is
signalled by a blue LED between both ILink connectors at these
Boxes. The LED must be off at all other Boxes.
Checks
The following checks should be done after startup:
o
All slave Boxes must display a valid address.
o
The termination LED must be turned on at the first and the last
Irinos-Box of the ILink cabling.
7.3 Network configuration
The Master-Box of the Irinos-System provides an integrated DHCP-
Server, which is activated at delivery state. The
IP address of the
Irinos-Systems is 192.168.3.99 , the subnet mask is
255.255.255.0. If the Ethernet-Interface of the PC is configured as
"DHCP-Client", a valid IP address is assigned to it (range
192.168.3.100 to 192.168.3.254). No further network
configuration is required.
In delivery condition the DHCP-Server of the Irinos-System
is activated. This is a good choice for a direct connection to
a PC.
42