2
IR Bullet Camera
INSTRUCTION MANUAL
2. INSTALLATION
Appearance
Step 1: Affix the camera
Affix th
e mounting template to the desired
location, knock in 4 plastic anchors after
hole drilling and then lock in 4 self-
tapping screws to fasten the c
amera.
If it would be installed on the metal pillar
without grounding out, please use the
rubber pad enclosed for isolation. (You
could select to use enclos
ed rubber pad
for better isolation.)
Step 2: Adjust the camera angle
1. Use the provided torx wrench to
loosen the torx screw on one side of
the mount bracket so that you can tilt
the camera.
2. Loosen the screw on the retainng ring
to adjust the camera angle.
3. After adjustments,
fasten the screws
and retaining ring back to the
camera.
Retaining ring
Torx screw
Step 3: Adjust the lens
Use a screwdriver to adjust the Near/
Far and Tele/Wide controls. After
adjustment, be sure to lock them tightly
for waterproof.
Tele/Wide
control
Joystick (inside)
Near/Far
control
Step 4: Adjust OSD Settings
To use the OSD joystick control:
•
Rotate the knob to remove the
joystick cover to expose the OSD
joystick.
•
Press the OSD joystick control
straight down to enter the Main menu
or a selected item.
•
Move the OSD joystick control UP,
DOWN, LEFT and RIGHT to navigate
through menus and options.
For further information on OSD settings,
refere to next section.
Step 5: Adjust the sun shield hood
Loosen the
screw (one circle), then mo
ve
the sunshield hood forward and backward
to adjust the position of sunshade. Be
sure to adjust the sunshield hood in
coordination with lens in case of sunshade
problems.
