2. D/N LEVEL :
BLC2 :
Backlight compensation window is like
Set up a switch-over point from B/W mode to COLOUR mode.
Use the SELECT button to select HIGH or LOW Under the AUTO
mode, the switchover point of brightness from COLOUR mode to
B/W is 1.5 lux.
LOW :
The switchover point of brightness from B/W to COLOUR
mode is 4.5 lux.
(Centre Window)
HIGH :
The switchover point of brightness from B/W to COLOUR
mode is 7.5 lux.
BLC3 :
Backlight compensation window is like
( To switch between Colour mode and B/W mode withina short time,
use this setup.)
3. D/N FIL :
ON : Y-signal filter of CCD output is narrow in B/W mode. In this
position, the horizontal resoulation is 480TV lines
OFF : Y-signal filter of CCD output is wide in B/W mode. In this
(Bottom Window)
position, the horizontal resoulation is 600TV lines
(If there is horizontal noise in B/W mode,set to ON)
4. SHUTTER :
BLC4 :
Backlight compensation window is like
Selection of shutter speed from AUTO to 1/10K. Sequentially
contains AUTO, 1/50(PAL) or 1/60(NTSC), 1/120(PAL) or 1/100(NTSC)
, 1/250, 1/500, 1/1K, 1/2K, 1/4K, 1/10K.
When the slide switch is set to :
AES Mode :
Shutter will be able to select from AUTO to 1/10K
DC/VIDEO Mode :
Shutter will be able to select from 1/50(PAL) or
(Top Window)
1/60(NTSC) to 1/10K.
5. GAIN :
STD :
Standard position, GAIN=22dB.
9. WHITE BAL :
WIDE :
High-sensitivity position, GAIN=30dB.
ATW1(INDOOR) :
6. SYNC :
TTL auto trace white balance algorithm is designed to implement a
INT : The camera is in the internal SYNC mode.
perfect colour reproduction. Colour temperature range is 2600
o
K~6000
o
K.
LL :
The camera is in the LineLock Mode.
ATW2(OUTDOOR) :
Adjusting degrees by V-PHASE control on the side panel.
TTL auto trace white balance algorithm is designed to implement a
7. GAMMA :
perfect colour reproduction. Colour temperature range is 2500
o
K~9500
o
K.
Selection of GAMMA curvature for GAMMA correction.
AWC :
0.45 and 1 are able to select.
The white balance is automatically adjusted, within 3 seconds, to the
8. BLC :
correct colour temperature of the environment.
Selection of backlight compensation mode.
MANUAL :
OFF :
The BLC function is off.
Manually adjust the R and B (red&blue) values.
BLC1 :
Backlight compensation window is like
10. APERTURE :
Selection of picture sharpness (HIGH, LOW, MID).
11. PDSP :
(Pre-determined shutter speed)
Preset of shutter speed. When external controler active this functon,
shutter speed will be change to preset value.
(Bottom-Centre Window)
(Manually according to a RJ-45 PREDTMSP command.)
- 8 -
- 9 -