28
Monogramming and embroidering with embroidery hoop*
-
-
-
-
-
- Draw the desired lettering or design on the right side of the
fabric.
- Stretch the fabric between embroidery hoop as firmly as
possible.
- Place the fabric under the needle. Make sure the presser foot
bar is down in its lowest position.
- Turn the balance wheel towards you to bring up the lower
thread through the fabric. Sew a few securing stitches at the
starting point.
- Hold the hoop with thumb and forefingers of both hands while
pressing the material with the middle and third fingers and
supporting the outside of hoop with smaller finger.
* Embroidery hoop not included with machine.
Preparation for Monogramming and Embroidering*
Set the machine as illustrated above.
Remove the presser foot and the presser foot holder.
Attach the darning plate.
Lower presser foot lever before starting to sew.
Adjust the stitch width according to the size of lettering or
design.
2-dial model only
